Profile structure of magnetic flux lines in type-II superconductor from a rectangular electron hologram

Profile magnetic configuration of a quantized flux line and flux-line lattice penetrating a type-II superconductor thin foil, niobium, was observed by electron holography and Lorentz microscopy using a 300 kV field-emission electron microscope. Each single flux line was distributed periodically as lattice structure in the mixed state just below its critical temperature of 8.5 K, while at low temperature of 5 K the flux lines were weakly bound as bundles. In order to observe the flux-line distribution over a wide area, discrete Fourier transform reconstruction in the holography was extended for a rectangular area without loss of information and data precision.     

Roasting effects on the distribution of tocopherols and phospholipids within each structural part and section of soybeans

To clarify the effects of microwave roasting on the distribution of tocopherols and FA of phospholipids within soybeans, whole soybeans (Glycine max) were treated by microwave and further evaluted as compared to a raw sample. Tocopherol homologs, measured using HPLC, and phospholipid profiles, quantified with GC, were determined in the seed coat, the embryonic axis, and selections of cotyledons separated from three cultivars. The tocopherols were predominantly detected in the axis, followed by the cotyledons, and then very little in the coat. As much as 25% of the individual tocopherols originally present in the coat were lost at 12 min of roasting, whereas <25% was lost in the cotyledons and the axis after 20 min of roasting. The greatest rate of phospholipid loss (P<0.05) was observed in PE, followed by PC and PI, and their changing patterns were more pronounced in the coat than in the cotyledons or the axis. Thus, tocopherol content and phospholipid profiles change with microwave roasting according to tissue.     

Twisted bit-line architectures for multi-megabit DRAMs

As the memory cell array of DRAM has been scaled down, inter-bit-line coupling noise has emerged as a serious problem. The signal loss due to this noise is estimated at about 40% of the signal amplitude in a polycide-bit-line 16-Mb DRAM with a technologically attainable scaling scheme. Twisted bit-line architectures to reduce or eliminate the noise are proposed and demonstrated by the soft-error rate improvement of a 1-Mb DRAM. The effective critical charge is improved by 35%, which is attributed not only to the improvement of the signal amplitude but also to the elimination of large coupling noise during the sensing operation. The impact of these twisted bit-line architectures from a scaling viewpoint is also examined, and they are shown to be promising candidates for overcoming the scaling problems of DRAMs     

AC side harmonic and phenomena accompanying DC-injection of utility-interactive PV system

The experiments investigated phenomena related to direct contact between the DC output of a PV array and the AC power from the utility grid. The results show that the DC power flows through the distribution transformers (DC-injection) saturating their magnetic circuits. The saturation of magnetic circuits makes peak currents, incorporating a large portion of even harmonics, flow through the high-voltage side of the distribution transformer, adding the level of harmonic distortion of its exciting current. With the increase of injecting DC-current to the utility grid, peak currents at the primary side of distribution transformer increases the most, and even among the same effective (rms) values, the increase of primary side current is larger than that of the secondary side current.     

Source-synchronization and timing vernier techniques for 1.2-GB/sSLDRAM interface

This paper describes a validation system for an SLDRAM interface. The SLDRAM system utilizes two techniques to achieve a high data-transfer rate with a conventional module mounting style. The first technique is a source-synchronization scheme. Since the chip that transmits data also supplies the data clock, the clock and data are completely synchronous. The second is the timing vernier technique. A wait time for output data is programmable in each SLDRAM. Therefore, the time at which data arrive at the controller from any SLDRAM can be set by the controller with a 200-ps step size. The validation chip is designed to emulate these operations. The chip is fabricated using a 0.35-μm CMOS process technology and packaged in a conventional 0.65-mm pitch thin small out-line package, mounted on a single-chip module, and put into an eight-module system. A stub series terminated logic (SSTL)-like interface is adopted for high-speed signals. From system-level measurements, the data eye width of 600 ps is obtained at a data rate of 600 Mbps. Errorless data transmission is observed in both read and write operations in a bit-error rate testing. The validation system has successfully demonstrated a data-transmission rate of 1.2 GB/s (600 Mbit/s/pin) using source-synchronization and timing vernier techniques at the supply voltage of 2.5 V     

Attractants for Rice Leaf Bug, <Emphasis Type="BoldItalic">Trigonotylus caelestialium</Emphasis> (Kirkaldy), are Emitted from Flowering Rice Panicles

Volatiles were extracted from rice plants of various growth stages with solid-phase microextraction (SPME) and analyzed by gas chromatography-mass spectrometry (GC-MS) to identify attractants that cause invasion of the rice leaf bug Trigonotylus caelestialium (Kirkaldy) into paddy fields. The composition of volatile blends produced by rice plants changed with rice development. In addition, volatile blend compositions differed between the panicles and the stems and leaves. The relative geranyl acetone content was high in all plant structures analyzed. In volatiles from whole plants in the fourth-leaf stage and panicles in the full-ripe stage, the relative content of green leaf volatiles (GLVs) was higher than that found in other rice plant structures. In contrast, relative terpene levels emitted from whole plants in the panicle-formation stage and by panicles and stems and leaves in the flowering stage were higher than those of other rice plant structures. However, the type of terpenes found differed between the panicles and the stems and leaves. Relative levels of β-caryophyllene in whole plants in the panicle-formation stage and panicles in the flowering stage were much higher than that in stems and leaves in the flowering stage. Our previous studies demonstrated that the odor from whole plants in the panicle-formation stage and panicles in the flowering stage is attractive to rice leaf bugs. Here, the attractiveness of β-caryophyllene to adult bugs was investigated in olfactometer assays. Adult females were attracted to β-caryophyllene at a concentration of 0.001%, which is approximately equivalent to the concentration produced by flowering rice panicles. However, β-caryophyllene also was present in the odor of whole plants in the fourth-leaf stage and in stems and leaves in the flowering stage. Furthermore, the amounts of this compound emitted from these structures were similar. Therefore, we suggest that the relative abundance of this compound in a volatile blend is important for attractance of the bugs.     

Theoretical limitations of a Hopfield network for crossbarswitching

It has been reported through simulations that Hopfield networks for crossbar switching almost always achieve the maximum throughput. It has therefore appeared that Hopfield networks of high-speed computation by parallel processing could possibly be used for crossbar switching. However, it has not been determined whether they can always achieve the maximum throughput. In the paper, the capabilities and limitations of a Hopfield network for crossbar switching are considered. The Hopfield network considered in the paper is generated from the most familiar and seemingly the most powerful neural representation of crossbar switching. Based on a theoretical analysis of the network dynamics, we show what switching control the Hopfield network can or cannot produce. Consequently, we are able to show that a Hopfield network cannot always achieve the maximum throughput.     

A new perspective on the characterization of materials for a-Si:H solar cells

A study has been carried out on a-Si:H solar cell materials fabricated under a wide range of deposition conditions in different laboratories. The results on both thin films and corresponding Schottky barrier cell structures demonstrate that analysis and characterization based solely on the neutral dangling bonds are clearly inadequate. Contributions of charged defects to the properties of a-Si:H, their effect on light-induced changes are identified together with the limitations of methods commonly used to characterize the solar cell properties and stability of a-Si:H materials. Self-consistent fitting of a wide range of results on films and Schottky barrier cell structures is obtained with a gap state distribution in which charged defects are included.     

Power system voltage control by distributed expert systems

A case study of the application of a distributed control scheme to a power system control is presented. In addition, an investigation has been conducted into voltage control. Combined injection of VAr-compensating devices controlled by distributed expert systems has been proposed as a measure to maintain voltage stability in a power system under heavy loading conditions. A simulation study has been carried out by using five workstations that represent a power system and four VAr-compensating devices. The results demonstrate the effectiveness of the proposed system for voltage recovery